آپلود برنامه از طریق برنامه اردوینو به اتمگا8

آپلود برنامه از طریق برنامه اردوینو به اتمگا8 به وسیله پروگرمر پارالل

شهنازی, [۲۰.۱۲.۱۵ ۲۲:۱۵]
So it is possible use the Atmega8, but you need to upload Arduino NG or older w/ ATmega8 bootloader to the chip and check your code (mind the libraries!) for use of hardware that is not present at Atmega8.

To burn the bootloader I am using a Parallel Cabe, like this: http://arduino.cc/en/Hacking/ParallelProgrammer

And follow the sequence below to burn it:

Choose menu Tools > Boards > Arduino NG or older w/ ATmega8
Choose menu Tools > Programmer > Parallel Programmer
Menu Tools > Burn Bootloader
That's it! Regards Renato Aloi

شهنازی, [۲۰.۱۲.۱۵ ۲۲:۱۵]
https://www.arduino.cc/en/Hacking/ParallelProgrammer